Leon Mk1
Cooling system components, coolant pump side |
1 - | Main toothed belt |
q | Mark the direction of rotation before removing it |
q | Check for wear |
q | Do not bend |
q | Remove and install, tighten → Chapter |
q | Toothed belt routing → Fig. |
2 - | Gasket |
q | Replace |
q | In some cases, the pump comes with the silicone gasket incorporated |
3 - | Coolant pump |
q | Check that it turns smoothly |
q | In the event of fault or leakage: replace complete unit |
q | Remove and install → Chapter |
4 - | 10 Nm |
5 - | Rear toothed belt shield |
6 - | Upper toothed belt shield |
7 - | Lower toothed belt shield |
8 - | 10 Nm |
9 - | Pulley |
q | Check the fastening when fitting |
q | Remove and install the Poly-V belt → Chapter |
10 - | 90 Nm + 1/4 turn (90°) |
q | Replace |
q | Fit lubricated |
q | The tightening may be carried out in several stages |
q | The tightening angle can be measured with protractor -T20030- |
11 - | 10 Nm |
q | Replace |
12 - | 20 Nm |
13 - | Toothed belt-crankshaft pinion |