Leon Mk1
|
1 - | Support |
2 - | Bolt with cutting thread |
3 - | From the radiator down |
q | → Item |
q | Coolant hose connection diagram → Chapter |
4 - | Connecting hose |
5 - | O-ring |
q | Replace |
6 - | Coolant thermostat |
q | Test functioning: Warm the thermostat in water. The tip of the heat element should emerge |
q | Temperature test: Opening initiation (approx. 84°C) and end (approx.98° C) not realistic |
7 - | To the upper expansion tank |
q | Coolant hose connection diagram → Chapter |
8 - | To the heat exchanger |
q | Coolant hose connection diagram → Chapter |
9 - | From the expansion tank |
q | → Item |
q | Coolant hose connection diagram → Chapter |
10 - | Fastening clip |
q | Check for firm seating |
11 - | From the heat exchanger |
q | Coolant hose connection diagram → Chapter |
12 - | Coolant pump housing in engine block |
13 - | Ring gasket |
q | Replace |
14 - | Coolant line |
15 - | Thermostat housing |
16 - | 10 Nm |
17 - | Coolant temperature sender -G62- |
q | Green |
q | To engine control unit |
q | With coolant temperature gauge sender -G2- |
q | Before removing, reduce the cooling system pressure |
18 - | Plug |
q | Before removing, reduce the cooling system pressure |
19 - | To the radiator, upper part |
q | → Item |
q | Coolant hose connection diagram → Chapter |