Leon Mk1
| Ignition system components: removing and fitting |
| 1 - | Sparkplug wire |
| q | With anti-static connector and sparkplug hood |
| q | Resistance 4,8…7,2 kΩ |
| q | Test the continuity of flow |
| 2 - | Ignition transformer -N152- |
| q | With markings for ignition wiring |
| A = cylinder 1 |
| B = cylinder 2 |
| C = cylinder 3 |
| D = cylinder 4 |
| q | Location → Chapter |
| 3 - | Connector |
| q | Black, 4 contacts |
| q | For ignition transformer -N152- |
| 4 - | 10 Nm |
| 5 - | Connector |
| q | Black, 2 contacts |
| q | For knock sensor 1 -G61- |
| q | Gold contacts in sensor and connector |
| 6 - | Knock sensor 1 -G61- |
| q | Location → Chapter |
| 7 - | 20 Nm |
| q | The tightening torque affects the functioning of the knock sensor |
| 8 - | Connector |
| q | Black, 3 contacts |
| q | For Hall sender -G40- |
| 9 - | Hall sender -G40- |
| q | Location → Chapter |
| 10 - | O-ring |
| q | Replace if worn |
| 11 - | Sparkplug, 30 Nm |
| q | Remove and fit with sparkplug spanner -T20028- |
| q | Type and separation of electrodes → Chapter |
| 12 - | Ignition wiring guide |