SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Radiator and radiator fans >
< Coolant pump and thermostat
Leon Mk1
Power unit
4 cylinder Direct injection engine, turbocharger
Engine cooling
Parts of cooling system
Expansion tank,removing and fitting
Expansion tank,removing and fitting
Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda
→ Chapter
.
Special tools and workshop equipment required
t
Base -T20174-, see equivalent
→ Anchor
t
Torque wrench (5... 50 Nm) -V.A.G 1331-, see equivalent
→ Anchor
Expansion tank: Removing
→ Anchor
Expansion tank: Fitting
→ Anchor
Removing
–
Switch ignition OFF.
–
Drain coolant
→ Chapter
.
–
Disconnect the coolant hoses
-1-
and
-2-
in the expansion tank.
–
Pull out the plug
-3-
.
–
Undo the bolts
-arrows-
and remove the expansion tank
-4-
.
Installing
Install in reverse order to dismantling, noting the following:
–
Fill up with coolant
→ Chapter
.
–
Electrical connections and cable layout:
→ Current flow diagrams, Electrical fault finding and Fitting locations
Power unit
4 cylinder Direct injection engine, turbocharger
Engine cooling
Parts of cooling system
Radiator and radiator fans >
< Coolant pump and thermostat