Leon Mk1
Oil tray and oil pump - Assembly overview |
1 - | Oil level/oil temperature sender -G266- |
q | Depending on version |
2 - | Seal |
q | Replace |
3 - | Bolt. |
q | Replace |
q | Tightening sequence → Fig. |
4 - | Lower element on the case |
q | Removing and installing → Chapter. |
5 - | Bolt. |
q | 9 Nm. |
6 - | Anti-surge valve |
q | Replace |
7 - | Bolt. |
q | 9 Nm. |
8 - | Oil pump: |
q | Removing and installing → Chapter. |
9 - | Centring sleeve |
10 - | Chain tensioner |
11 - | Bolt. |
q | 9 Nm. |
12 - | Bolt. |
q | Only on engines with identification letters CCZB - CDAA |
q | 9 Nm. |
13 - | Valve for oil pressure control -N428- |
q | Only on engines with identification letters CCZB - CDAA |
q | Removing and installing → Chapter. |
14 - | O ring |
q | Only on engines with identification letters CCZB - CDAA |
q | Replace |
15 - | Chain for operating oil pump |
q | Mark direction of rotation before removing |
16 - | Seal |
q | Replace |
17 - | Coarse oil separator |
q | Removing and installing (engine code BYT) → Chapter |
q | Removing and installing (engine codes BZB - CCZB - CDAA) → Chapter |
18 - | Bolt. |
q | Tightening sequence (engine code BYT) → Fig. |
q | Cylinder drive train: Installation survey (engine codes BZB - CCZB - CDAA) → Fig. |
19 - | Upper element on the case |
q | Removing and installing → Chapter. |
20 - | Bolt. |
q | 9 Nm. |
21 - | Bolt. |
q | Replace |
q | Tightening sequence → Fig. |
22 - | Suction pipe |
q | Clean strainer if dirty |
23 - | O ring |
q | Replace |
24 - | Seal |
25 - | O ring |
q | Replace |
26 - | Retaining valve |
27 - | Oil drain plug |
q | Replace |
q | 30 Nm. |
28 - | Nut |
q | 9 Nm. |
|
|
|