SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Removing and installing sealing flanges and flywheel or drive plate >
< Crankshaft
Leon Mk1
Power unit
4 cylinder Injection engine (1.4 l, 4 Direct injection valve, turbocharger and volumetric compressor)
Enginecrankshaft group, pistons
Pistons and conrods: dismantling and assembling
Separating new conrod
Separating new conrod
It is possible that the two parts of a new conrod are not completely separated as intended. If it is not possible to take off the conrod bearing cap by hand, proceed as follows:
–
Mark cylinder allocation of conrod
→ Item
–
Gently clamp conrod, as shown in illustration, in a vice with soft aluminium jaws.
Note
t
Secure the conrod slowly so that it does not break.
t
The conrod is attached below the cutting line.
–
Unscrew the two bolts
-arrows-
. approx. 5 turns.
–
Using a plastic hammer, carefully knock on the bearing cover of the con-rod toward
-arrow-
until it releases.
Power unit
4 cylinder Injection engine (1.4 l, 4 Direct injection valve, turbocharger and volumetric compressor)
Enginecrankshaft group, pistons
Pistons and conrods: dismantling and assembling
Removing and installing sealing flanges and flywheel or drive plate >
< Crankshaft