Leon Mk1
Fuel rail with injectors - Assembly overview |
1 - | O ring |
q | Replace |
q | Before installing moisten with clean engine oil |
2 - | Elastic element |
q | Replace every time the lower part of the intake manifold is removed |
q | Ensure proper seating on injector. |
3 - | Injector, cylinder 4 -N33- |
q | Injector, cylinder 1 -N30- |
q | Injector, cylinder 2 -N31- |
q | Injector, cylinder 3 -N32- |
q | With Teflon seal and support washer. |
q | After dismounting the injector, the Teflon seal and support washer should be replaced → Chapter |
q | Injection valves: removing and fitting → Chapter |
4 - | Intake manifold lower part |
Caution
|
q | To remove and install: using "bracket for 5/16" bits" -V.A.G 1766/2- and Bit -3320/2- |
q | To remove, removing and installing regulating flap control unit -J808-, throttle valve module -J338- and intake manifold → Chapter. |
|