seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Engine cylinder head, valve gear > < Removing and installing poly V-belt

Leon Mk1

Separating new conrod
Separating new conrod
On new conrods it is possible that the breaking point is not fully separated. If it is not possible to take off the conrod bearing cap by hand, proceed as follows:
–  Mark cylinder allocation of conrod → Item
   
–  Gently clamp conrod, as shown in illustration, in a vice with soft aluminium jaws.
  Note
t  Secure the conrod slowly so that it does not break.
t  The conrod is attached below the cutting line.
–  Unscrew the two bolts -arrows-. approx. 5 turns.
  N13-10285
–  Using a plastic hammer, carefully knock conrod bearing cap loose in direction of -arrow-.
  N13-10286

Engine cylinder head, valve gear > < Removing and installing poly V-belt