–
| Remove the crank shaft gear with the extractor -T20178- and the Set -U-40100A- withAdapter -U-40100/PP- and use the key with the adapter off to protect the crankshaft pin key -U-40090-. Attach adapter -U-40100/7- as shown in illustration for safety and to achieve a compact unit. |
Installation is carried out in the reverse order of removal while noting the following: |
WARNING |
–
| Heat the chain sprocket in the oven for about 15 minutes at 220 ºC. |
l
| Installation location: The wide edge of the sprocket points to the engine. |
–
| Fit chain sprocket on crankshaft axle using pliers. |
|
|
|