Cleaning norms when working in the gearbox |
t
| Thoroughly clean unions and adjacent areas before removing. |
t
| Place removed parts on a clean surface and cover. Use plastic and paper. Do not use materials which fray! |
t
| Carefully cover or seal open components if repairs cannot be carried out immediately. |
t
| Only fit clean parts: only remove replacement parts from packaging immediately prior to installation. |
t
| O-rings, flanges and gaskets should always be replaced. |
t
| Always replace paper gaskets, completely disposing of the used gasket and thorougly cleaning the contact surfaces. |
t
| The thread of bolts threaded with a fixing agent should be cleaned using a wire brush. Then, fit the bolts with paste → Parts catalogue. |
|
|
|