Securing engine to assembly stand

Make

SEAT

Model

Leon Mk2

Section

Engine assy,cylinder block,crankcase › Removing and installing engine › Securing engine to assembly stand

Power unitSecuring engine to assembly stand

Securing engine to assembly stand

Consult the equivalence table for tools and equipment according to applicability among Seat / VW / Audi / Skoda → Chapter.

Diagram not available

Special tools and workshop equipment required

t	counterhold -T20127-, see equivalent → Anchor

t	base -T20172/1-, see equivalent → Anchor

t	Tower -T20172/2-, see equivalent → Anchor

t	Engine bracket -T20172/3-, see equivalent → Anchor

t	Workshop hoist

Conditions l  Gearbox is separated from engine Procedure   Note To align the assembly centre fit the counterhold -T20127- to the anchorage points as shown in the figure.

–  Insert struts of the retaining device -T20127-. into the corresponding anchorage points.   WARNING Ensure that the hooks are closed with the security sleeves. –  Using the workshop crane -T10416-, separate the engine from the engine support by lifting and lowering it.   Note If operations are planned for the crankshaft or sealing flanges, the flywheel and intermediate plate must be removed before fixing to the engine bracket -T20172/3-.

Diagram not available

–  Place the engine support -T20172/3- carefully on the engine, and then fasten it on the base -T20172/1- together with the tower -T20172/2-. –  Position the engine in the support -T20172-.

Diagram not available

05 Engine