Vehicle electricsBattery terminal connection
| Battery terminal connection |
Warning | To prevent damage to the battery terminal clamps and battery terminals, the following should be observed: |
| t
| The battery terminal clamps should only be fitted by hand and without using force. |
| t
| Battery terminals should not be coated with grease. |
| t
| The battery terminal clamps should be fitted so that the battery terminal is either flush with the clamp or protruding from it. |
| t
| Once the battery terminal clamps have been tightened to the specified torque, the threaded connections should not be tightened any further. |
| t
| When batteries are connected, the procedure described in the workshop manual must be strictly followed → Chapter. |
|
|
|
|
| The torque settings for battery terminal clamp -1- and additional terminal clamp -2- can be gleaned from the “Torque settings” table → Chapter. |
|
|
Diagram not available
|
06 General
