seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Power distributor: Removing and installing > < Fuse holder: Removing and installing

Leon Mk2

Relay carrier: removing and installing
Relay carrier: removing and installing
  Caution
Follow the instructions in the repair manual for disconnecting and connecting the battery to the letter .
Removing:
–  Disconnect battery.
–  Remove the on-board network control unit -J519-.
   
–  Release the fastening tabs -arrows- of the relay carrier -1- and remove the relay carrier -1- from its housing -2-, as far as the length of the cable will allow.
  N97-10221
–  Remove the relays -arrows- from the relay carrier -1-.
  Note
The number of relays depends on the vehicle equipment.
  N97-10222
–  Press the connector retention tabs -1- opening them in the -direction of the arrow-. Run the connectors -1- through the relay carrier.
Installing:
Installation is carried out in the reverse sequence; note the following:
  Note
  N97-10223
When installing the relay carrier -1- make sure the relay carrier fits “correctly” into its housing -2- and the retaining tabs -arrows- fit in “correctly”.
  N97-10221

Power distributor: Removing and installing > < Fuse holder: Removing and installing