Fabia Mk1
| Assembly overview of the handbrake |
| 1 - | Handbrake lever |
| q | removing and installing: |
| – | Remove centre console → Body Work → Rep. gr.68. |
| q | Assignment → Electronic Catalogue of Original Parts |
| 2 - | Cover |
| q | removing: |
| – | Press down the catch pegs at the bottom of the trim panel with a small screwdriver and pull off the trim towards the front. |
| q | Installing: |
| – | Slide the trim panel until the catch peg catches onto the hand-brake lever. Check trim panel catch. |
| q | Assignment → Electronic Catalogue of Original Parts |
| 3 - | Compensating clamp |
| 4 - | Adjusting nut |
| q | Setting the hand-brake → Chapter. |
| 5 - | Grommet |
| q | removing: |
| – | Pull hand-brake cable from guide tube. |
| – | Release grommet. |
| – | Pull grommet from guide tube. |
| q | Installing: |
| Installation is carried out in the reverse order. After installing make sure the grommet fits correctly in the body recess. |
| 6 - | Right guide tube |
| q | for hand-brake cable |
| 7 - | Left guide tube |
| q | for hand-brake cable |
| 8 - | Hand-brake cable |
| q | removing and installing → Chapter |
| q | check fitting position: |
| The positioning ring of the hand-brake cable must be located in the recess of the retaining clip. |
| 9 - | Hand-brake lever support |
| q | welded to the body tunnel |
| 10 - | Switch for hand-brake control -F9- |
| q | clipped onto hand-brake lever |
| q | replace if defective |
| 11 - | Self-locking hexagon nut, 20 Nm + 90° |
| q | replace after each removal |