Fabia Mk1
Crankshaft - Summary of components |
1 - | Bearing shells 1, 2, 3, 4 and 5 |
q | for bearing cap without lubricating groove |
q | for cylinder block with lubricating groove |
q | used bearing shells must not be mixed up (mark) |
2 - | 65 Nm + torque a further 90° (1/4 turn) |
q | replace |
q | tighten thread |
3 - | Bearing caps |
q | Bearing cap 1: belt pulley side |
q | Bearing cap 3: with recesses for thrust washers |
q | retaining lugs of the bearing shells of the cylinder block/bearing cap must be on top of one another |
4 - | Bearing shell 3 |
q | for bearing cap without lubricating groove |
q | for cylinder block with lubricating groove |
5 - | Thrust washers |
q | for bearing shell 3 |
q | pay attention to the marking |
6 - | Rotor |
q | for engine speed sender -G28- |
q | replace if damaged |
7 - | 10 Nm + torque a further 90° (1/4 turn) |
q | replace |
8 - | Fit pin |
q | Checking projection from crankshaft → Fig. |
9 - | Crankshaft |
q | Axial play when new: 0.07 up to 0.17 mm |
Wear limit: 0.37 mm |
q | Crankshaft bearing pins: Ø 54.00 mm |
q | Conrod bearing pin: Ø 47.80 mm |
10 - | Thrust washers |
q | for cylinder block, bearing 3 |
|