skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Crankshaft, Piston and Conrod > < Replacing gasket ring on belt pulley side

Fabia Mk1

Removing and installing the sealing flange on the belt pulley side
Removing and installing the sealing flange on the belt pulley side
Special tools and workshop equipment required
t  Guide bushing -T10053/1-
t  Counterholder -T30004-
t  Silicone sealant -D 176 404 A2-
t  Sealant remover gasket stripper (bearing code GST, bearing article no. R 34402), manufacturer Retech s.r.o.
t  Cleaning and degreasing agent, e.g. -D 009 401 04-
t  Protective goggles and gloves
Removing
–  Remove the right wheelhouse liner → Body Work; Rep. gr.66.
–  Remove V-ribbed belt → Chapter.
–  Removing toothed belt → Chapter.
   
–  Remove crankshaft - toothed belt sprocket. To this end lock the toothed belt gear with counterholder -T30004-.
  Note
When screwing on the counterholder place 2 washers between the timing belt gear and the counterholder.
–  Removing the oil pan → Chapter.
–  Unscrew sealing flange on belt pulley side.
–  Remove sealing flange on belt pulley side, if necessary release by applying slight blows with a rubber-headed hammer.
  WARNING
Wear protective gloves when working with sealant and grease remover!
–  Remove gasket residues on cylinder block with sealant remover.
–  Clean sealing surfaces, they must be free of oil and grease.
Install
  Note
t  Pay attention to the use by date on sealant.
t  The sealing flange must be installed within 5 minutes after applying the silicone sealant.
  S13-0231
–  Cut off nozzle tube of silicone sealant -D 176 404 A2- at the front marking (Ø of nozzle approx. 3 mm).
  N17-0019
–  Apply silicone sealant bead to the clean sealing surface of the sealing flange, as shown in the illustration.
   Thickness of sealant bead -arrow-: 2 to 3 mm.
  Note
The sealant bead must not be thicker than 3 mm otherwise excess sealant may get into the oil pan and clogg the strainer in the oil suction pipe.
–  Fit sealing flange immediately and lightly tighten all bolts.
  Note
  A17-0028
When installing the sealing flange with the gasket ring fitted use guide bushing -T10053/1-.
–  Tighten the fixing screws of the sealing flange crosswise.
   Tightening torque: 15 Nm
–  Installing the oil pan → Chapter.
  Note
After installing, allow the sealant to dry for about 30 minutes. Only then may engine oil be filled in.
–  Installing the timing belt → Chapter.
–  Install the V-ribbed belt → Chapter.
  S13-0194

Crankshaft, Piston and Conrod > < Replacing gasket ring on belt pulley side