skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Testing oil pressure and oil pressure switch > < Removing and installing oil pan

Fabia Mk1

Removing and installing oil pump
Removing and installing oil pump
Removing
–  Removing the oil pan → Chapter.
   
–  Screw out screw -1- and unclip the chain guard for the oil pump -2- in the area of -arrow-.
  S17-0086
–  Release screw -2-.
–  Swing the chain tensioner for the oil pump drive -4- in the -direction of the arrow- and remove the sprocket for the oil pump from the oil pump.
   The sprocket for the oil pump stays in the chain for the oil pump.
–  Screw out screws -1- and remove the oil pump from the cylinder block.
Install
Installation is carried out in the reverse order. Pay attention to the following:
t  The oil pump must sit in the sleeves then tighten to 24 Nm.
t  Replace the sprocket screw for the oil pump, tightening torque: 20 Nm + torque a further + 90° (1/4 turn).
  S17-0087

Testing oil pressure and oil pressure switch > < Removing and installing oil pan