| Install gearbox (Fabia II, Roomster, Rapid) |
| Installation is carried out in the reverse order. Pay attention to the following: |
Note | t
| When performing installation work replace the self-locking nuts and screws. |
| t
| Replace screws which have been tightened to a torquing angle as well as gasket rings and seals. |
| t
| Check whether the dowel sleeves for centering the gearbox are present in the cylinder block, insert if necessary. |
| t
| All cable straps which are detached or cut open when removing, should be fitted on again in the same place when installing. |
| t
| Before installing the gearbox one should ensure that the torque converter is correctly installed in the gearbox → Chapter. |
WARNING | If the converter is installed wrongly the driver of the torque converter or the ATF pump will be destroyed when the gearbox on the engine is connected at its flange. |
|
| –
| Inspect ATF level, if necessary top up with ATF → Chapter. |
| –
| Inspect setting of selector lever control cable and adjust if necessary → Chapter. |
|
|
|
