| Inspect setting of selector lever control cable |
| l
| The gearshift mechanism is checked → Chapter. |
| –
| Pull selector lever out of position „P“ with the button pressed, approx. 5 mm to the rear and hold, do not shift into position „R“. |
| –
| Release the selector lever. |
| l
| The selector lever must automatically jump back again into the position „P“. |
| –
| If this is not the case, then the gearshift mechanism must be set → Chapter. |
| –
| Shift selector lever to position „N“. |
| –
| Pull selector lever out of position „N“ with the button pressed, approx. 5 mm to the rear and hold, do not shift into position „D“. |
| –
| Release the selector lever. |
| l
| The selector lever must automatically jump back again into the position „N“. |
| –
| If this is not the case, then the gearshift mechanism must be set → Chapter. |
| –
| Pull selector lever out of position „N“ with the button pressed, approx. 5 mm to the front and hold, do not shift into position „R“. |
| –
| Release the selector lever. |
| l
| The selector lever must automatically jump back again into the position „N“. |
| –
| If this is not the case, then the gearshift mechanism must be set → Chapter. |
|
|
|
