| Installation is performed in the reverse order, pay attention to the following points: |
Note | t
| The lock button must be fully pulled out for installing the selector lever grip. Then the lock button must be secured using a cable strap or with the assembly aid which was factory-delivered together with the new grip. |
| t
| If the lock button is not secured, it can no longer be pulled out of the selector lever grip using mechanical auxiliary tools. Press out the lock button if necessary by positioning a compressed air pistol on the underside of the grip. |
| –
| Press the selector lever grip completely onto the selector lever with a new warm-type clamp - the lock button points to the driver. |
| l
| During this procedure, the grip must latch in the annular groove on the selector lever. |
| –
| Remove cable strap or assembly aid. After the removal, the lock button actuator grips into the vertical groove of the selector lever, if necessary press the lock button into the selector lever grip. |
| –
| Tighten new warm-type clamp using the hose binding claw. |
|
|
|
