| Removing and installing parts of the exhaust system |
Note | t
| Always replace gaskets and self-locking nuts. |
| t
| After performing installation work on the exhaust system, make sure the exhaust system is not mounted under tension and has adequate clearance from the vehicle body. If necessary slacken the clamping sleeve(s) and collar clamp and align the silencer and exhaust pipe so as to create adequate clearance between these components and the vehicle body, and that the weight of the exhaust system is evenly distributed over the hangers. |
| t
| Use a screwdriver to slacken and tighten the clamps of the heat shields. Tightening torque: 2 Nm. |
| t
| Avoid a large deflection of the decoupling element at the front exhaust pipe (max. 10 °). |
| t
| Vehicles with engine identification characters AGU have only 1 lambda probe upstream of catalytic converter ⇒ Pos. 8. |
|
|
|
