skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing valve stem seals|Install > < Replacing valve stem seals

Octavia Mk1

Removing
Removing
–  Remove camshaft → Chapter.
  Note
t  Ensure that the used bearing shells of the camshaft are not mixed up (pay attention to marking).
t  When installing the camshaft, ensure it is correctly located in the retaining lugs of the bearing shells in the bearing caps and in the cylinder head.
t  Ensure that the bucket tappets are not mixed up, for this step mark the assignment with waterproof marker on the reverse side.
–  Remove bucket tappets (do not interchange) and lay aside with the contact surface facing down.
–  Position piston of the corresponding cylinder to dead centre.
   
–  Insert the assembly device for valves -MP 1-213- and adjust bearing to the stay bolt height.
–  Remove valve springs with valve lever -MP 1-211-.
  Note
The valves rest on the piston crown.
  S15-0171
–  Use pulling device -MP 1-206- to pull off valve stem seal.
   Press sleeve -1- down slightly during this step.
  S15-0172

Replacing valve stem seals|Install > < Replacing valve stem seals