–
| Release screws -A- (8 Nm). |
–
| Remove expansion valve -B- and threaded plate -E-. |
Installation is performed in the reverse order, pay attention to the following points: |
Note t
| Replace both “O”-ring seals -C- (14.0 mm; 1.8 mm) and -D- (10.8 mm; 1.8 mm). |
t
| Shut off open connections on the evaporator. |
t
| If the heat-protection insulation is missing or not correctly installed, it may result in a power reduction of the air conditiong system (change of the set control characteristic curve through heat irradiation). |
|
|
|