Octavia Mk1
| Adjusting works when replacing individual components |
| When working on the gearbox it is only necessary to re-set the drive wheel, input shaft with output gear or differential gear housing if parts were replaced that directly affect the setting of the final drive. To avoid unnecessary settings, refer to the following table: |
| Set: | |||
| Component to be replaced: | Differential gear housing with riveted pinion → Chapter | Drive wheel1) → Chapter | Input shaft with output gear1) → Chapter |
| Gearbox housing | X | X | X |
| Drive wheel1) | X | X | |
| Tapered-roller bearing for drive wheel | X | ||
| Output gear1) | X | X | |
| Drive pinion | X | ||
| Tapered-roller bearing for input shaft | X | ||
| Differential gear housing with pinion | X | ||
| Tapered-roller bearing for differential gear, bearing body or adjusting ring | X | ||
| Bearing support ring, parking gear or bearing cap | X |
| 1) Always replace the drive wheel and the output gear together. |
