Skoda Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Perform self-diagnosis >
< Removing and installing the four-wheel drive control unit J492
Octavia Mk1
Power transmission
Manual gearbox 02C
Self diagnosis, V.A.G Inspection Service
Electric/Electronic components and fitting locations
Removing and installing pump for Haldex coupling V181
Removing and installing pump for Haldex coupling V181
Removing and installing pump for Haldex coupling -V181-
Special tools and workshop equipment required
t
Multi-purpose tool -MP3-419 (VW 771)-
Removing
–
Switch off ignition.
–
Unscrew rear propshaft pipe with flexible disk and oscillation damper from rear final drive
-arrows-
and carefully push towards the front
→ Chapter
.
–
Disconnect plug of pump for Haldex coupling
-arrow 1-
.
–
Place a catch pan under the final drive.
–
Unscrew screws
-arrows 2-
.
–
Then turn the pump slightly to the right.
–
Pull out the pump in the
-direction of the arrow-
.
Install
Installation is carried out in the reverse order. Pay attention to the following:
–
Replace gasket
-A-
.
–
Replace O-rings
-B-
and
-C-
.
–
Pay attention to the different diameters:
t
Ø O-ring
-B-
= 31.5 mm
t
Ø O-ring
-C-
= 33 mm
–
Press in the pump up to the stop.
–
Tighten screws to 6 Nm.
–
Check oil level in Haldex coupling
→ Chapter
, if necessary change oil in Haldex coupling
→ Chapter
.
Power transmission
Manual gearbox 02C
Self diagnosis, V.A.G Inspection Service
Electric/Electronic components and fitting locations
Removing and installing pump for Haldex coupling V181
Perform self-diagnosis >
< Removing and installing the four-wheel drive control unit J492