skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Summary of components: suspension arm, track rod for rear axle, Rear left side vehicle level sensorG76 (vehicles with four-wheel > < Removing rear rubber-metal bearing

Octavia Mk2

Installing rear rubber-metal bearing
Installing rear rubber-metal bearing
Installation is carried out in the reverse order. Pay attention to the following:
   
Distinguishing feature of the rubber-metal bearing
I - Front rubber-metal bearing
II - Rear rubber-metal bearing
The front rubber-metal bearings have two recesses on the top side -arrows- and differ only slightly in the overall height → Electronic Catalogue of Original Parts.
The rubber-metal bearing must be installed in a certain direction, the markings on the assembly carrier should be observed.
  N42-10322
–  Insert rubber-metal bearing -1- into the assembly carrier in such a way, that the recess and the panel -arrows- point transversely to the direction of travel.
–  Position pressure plate -T10263/3--2- in such a way, that the flattened side also points transversely to the direction of travel.
  N42-10323
–  Insert special tool together with rubber-metal bearing as shown in the assembly carrier.
1 - Nut -T10263/5-
2 - Thrust piece -T10263/3-
3 - Rubber-metal bearing
4 - Thrust piece -T10263/2-
5 - Hydraulic cylinder e.g. -VAS 6178-
6 - Nut -T10263/5-
7 - Screw -T10263/4-
–  Pretension special tool with rubber-metal bearing.
–  Carefully install the rubber-metal bearing by actuating the pump, until the collar rests »free of gap« against the assembly carrier.
–  Install the rear silencer of the exhaust gas system → Engine → Rep. gr.26.
–  Installing the helical springs → Chapter.
–  Attach rear wheels.
  N42-10324
Tightening torques:
Assembly carrier to body
t  Use new screws!
90 Nm + 90°
Wheel bolts120 Nm

   

Summary of components: suspension arm, track rod for rear axle, Rear left side vehicle level sensorG76 (vehicles with four-wheel > < Removing rear rubber-metal bearing