skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing trailing arm with bracket > < Replacing the rubber-metal bearing for wheel-bearing housing

Octavia Mk2

Removing and installing the wheel hub with wheel bearing
Removing and installing the wheel hub with wheel bearing
Removing:
–  Remove wheel.
–  Remove coil spring → Chapter.
–  Removing drive shaft → Chapter.
–  Remove brake caliper with brake carrier and tie with wire to the body → Brake systems; Rep. gr.46.
  Note
Do not hang the brake caliper on the brake hose.
–  Screw out the Phillips head screws of the brake disc and remove brake disc.
–  Remove cover plate.
   
–  Release screws -2-.
–  Pull the wheel bearing out of the wheel-bearing housing.
Installing:
Installation is carried out in the reverse order. Pay attention to the following:
–  Tighten screw of drive shaft screwed connection:
t  Hexagon screw → Chapter
t  Twelve-sided bolt → Chapter
  S42-0224
Tightening torques:
Wheel hub with wheel bearing to wheel-bearing housing
t  Use new screws!
70 Nm +90°
Phillips head screw for front brake disc4 Nm
Wheel bolts120 Nm

   

Removing and installing trailing arm with bracket > < Replacing the rubber-metal bearing for wheel-bearing housing