skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Overview of the work sequence for vehicle alignment > < Measurement preliminaries
Vehicle alignment
Vehicle alignment
It is necessary to perform a vehicle alignment in the event of:
t  incorrect driving behaviour.
t  damage caused by accident and if parts have been replaced → Anchor
t  Components were removed → Anchor
t  there is unilateral tyre wear.
   
Vehicles with aluminium assembly carrier
Components replaced
Front axle:Chassis alignment requiredRear axle:Chassis alignment required
Component replacedYesNoComponent replacedYesNo
track control arm X 1)Bottom suspension armX 
Rubber-metal bearing
for track control arm
 X 1)Top suspension armX 
Wheel-bearing housingX Track rod for rear axleX 
Track rod/track-rod endsX Wheel-bearing housingX 
Steering gearX Assembly carrierX 
Assembly carrier XCoil spring X
Suspension strut XShock absorber X
Console for engine-gearbox assembly carrierX Anti-roll bar X
Anti-roll bar X 1)Trailing armX 

1) Precondition: The aluminium assembly carrier and consoles were fixed before removal → Chapter.
   
Vehicles with aluminium assembly carrier:
Removing and installing part of the axle
Front axle:Chassis alignment requiredRear axle:Chassis alignment required
Part of the axle removed and installedYesNoPart of the axle removed and installedYesNo
track control arm X 1)Bottom suspension armX 
Wheel-bearing housing XTop suspension armX 
Track rod/track-rod endsX Track rod for rear axleX 
Steering gearX Wheel-bearing housingX 
Assembly carrier X 1)Assembly carrierX 
Suspension strut XCoil spring X
Console for engine-gearbox assembly carrier X 1)Shock absorber X
Anti-roll bar X 1)Anti-roll bar X
   Trailing armX 

1) Precondition: The aluminium assembly carrier and consoles were fixed before removal → Chapter.
   
Vehicles with assembly carrier made of steel sheet:
Components replaced:
Front axle:Chassis alignment requiredRear axle:Chassis alignment required
Component replacedYesNoComponent replacedYesNo
track control arm XBottom suspension armX 
Rubber-metal bearing
for track control arm
 X 2)Top suspension armX 
Wheel-bearing housingX Track rod for rear axleX 
Track rod/track-rod endsX Wheel-bearing housingX 
Steering gearX Assembly carrierX 
Assembly carrier made of steel sheetX Coil spring X
Suspension strut XShock absorber X
Anti-roll bar X 2)Anti-roll bar X
   Trailing armX 

2) Precondition: the assembly carrier made of steel sheet was fixed before removal → Chapter.
   
Vehicles with assembly carrier made of steel sheet:
Removing and installing part of the axle:
Front axle:Chassis alignment requiredRear axle:Chassis alignment required
Part of the axle removed and installedYesNoPart of the axle removed and installedYesNo
track control arm XBottom suspension armX 
Wheel-bearing housing XTop suspension armX 
Track rod/track-rod endsX Track rod for rear axleX 
Steering gearX Wheel-bearing housingX 
Assembly carrier made of steel sheet X 2)Assembly carrierX 
Suspension strut XCoil spring X
Anti-roll bar X 2)Shock absorber X
   Anti-roll bar X
   Trailing armX 

2) Precondition: the assembly carrier made of steel sheet was fixed before removal → Chapter.
   

Overview of the work sequence for vehicle alignment > < Measurement preliminaries