skoda Workshop Repair Guides

Skoda Workshop Manuals

< PREV PAGE NEXT PAGE >
Summary of components of rear bumper (Octavia II) for vehicles as of 11.08
   
Summary of components of rear bumper (Octavia II) for vehicles as of 11.08
1 - 1.5 Nm
2 - 10 Nm
3 - Adjusting nut
4 - Right side holder
5 - Body-bound rivet
6 - Cover for towing lug
7 - 1.5 Nm
8 - Bumpers
Removing:
–  Remove the tailgate/luggage compartment cover → Chapter.
–  Removing rear lights → Electrical System → Rep. gr.94.
–  Remove expanding rivets (Pos. 5).
–  Remove screws (Pos. 7).
–  Remove screws (Pos. 1 and Pos. 10).
–  Remove both side trim panels in the luggage compartment and unscrew screws (Pos. 2).
–  Push rear bumper (Pos. 8) to the rear
  Note
Before removing the bumper it is necessary to disconnect plug of park sensors (if present).
Installing:
–  Installation is performed in the reverse order, pay attention to the following points:
  Note
Screws (Pos. 7) must be mounted successively from the centre of the bumper to the sides.
9 - Left side holder
10 - 1 Nm

   

Body > Body Work > Bumper > Rear bumper > Summary of components of rear bumper (Octavia II) for vehicles as of 11.08

< PREV PAGE NEXT PAGE >