Octavia Mk2
Summary of components - Vehicles with right-hand drive |
Note
The master brake cylinder and the brake servo unit can be replaced independently of one another. |
1 - | Screw cap |
– | check fitting position → Chapter |
2 - | Brake fluid reservoir |
3 - | Sealing grommets |
q | moisten with brake fluid and press in brake fluid reservoir |
4 - | Vacuum hose |
q | positioned in the brake servo unit |
5 - | Brake servo unit |
q | on petrol engines, the required negative pressure is drawn from the induction pipe or it is generated with a vacuum pump |
q | Vehicles fitted with petrol engines and automatic gearbox are equipped with a brake vacuum pump -V192- → Chapter. |
q | vehicles using a diesel engine are fitted with a vacuum pump for generating a low pressure → Chapter |
q | Functional test: |
– | With the engine off press down brake pedal repeatedly with force (this reduces the pressure already present in the device). |
– | Now hold the brake pedal in brake position using a medium foot pressure and start the engine. If the brake servo unit operates perfectly the brake pedal must yield noticeably under your foot (servo boost takes effect). |
q | if there are faults replace completely |
q | removing and installing → Chapter |
6 - | Gasket |
q | for brake servo unit |
7 - | Brake line, 14 Nm |
q | Master brake cylinder/push rod piston circuit THV to hydraulic unit |
8 - | Master brake cylinder |
q | cannot be repaired |
q | if there are faults replace completely |
q | removing and installing → Chapter |
q | Assignment → Electronic Catalogue of Original Parts |
9 - | Brake light switch -F- and brake pedal switch -F47- |
q | mounted as of 11.05 |
q | Fitting location: on master brake cylinder |
q | removing and installing → Chapter |
q | check → Vehicle diagnostic tester |
10 - | Screw, 5 Nm |
11 - | Protection plate |
q | Assignment → Electronic Catalogue of Original Parts |
12 - | Foot Controls |
q | different versions |
q | Assignment → Electronic Catalogue of Original Parts |
13 - | Gasket |
q | Assignment → Electronic Catalogue of Original Parts |
14 - | Screw, 25 Nm |
q | serves, at the same time, to secure the brake master cylinder and the brake servo unit. |
15 - | Nut, 50 Nm |
q | replace after each removal |
16 - | Brake line, 14 Nm |
q | Master brake cylinder/push rod piston circuit to hydraulic unit |
17 - | Screw, 3,5 Nm |