Skoda Workshop Service and Repair Manuals

Removing and installing timing belt for coolant pump Removing –  Remove small coolant pipe → Chapter.

–  Slackene coolant hose -2- and cable harness -1-. –  Unscrew screw -arrow- and remove bracket.

–  Unscrew screw -2- at bracket for pump for coolant after-running -V51-.

–  Remove coolant hoses -1 and 2- and lay to the side. –  Remove the front right wheelhouse liner → Body Work; Rep. Gr.66.

–  Screw out screws -arrows-. –  Remove charge-air pipe. To do so lift terminals -1 and 2-.

–  Unscrew oil scraper -1-.   Caution Risk of contamination to the lubrication system. Cover the opening for the oil with a clean cloth.

–  Screw out screws -arrows- and remove timing belt guard.

–  Unscrew screw -1- at drive wheel for coolant pump, to do so counterhold vibration damper.   Caution The screw at the drive wheel has a left-hand thread. –  Remove drive wheel -1- and toothed belt -2-. Install Installation is carried out in the reverse order. Pay attention to the following: t  Tightening torques: → Chapter   Note t  Replace screw for drive wheel. t  Pay attention to the fitting location of the toothed belt sprocket → Chapter. t  Replace O-rings and gaskets. –  Install oil scraper → Chapter. –  Install pump for coolant after-running -V51- → Chapter. –  Install small coolant pipe → Chapter.