Skoda Workshop Service and Repair Manuals

Replace coolant temperature sender -G62- Removing

–  Remove cover for air intake pipe, to do so release lateral retaining clasps -arrows-.

–  Release screws -arrows- for the air intake connection -1- and take connecting hose -2- out of the guide.

–  Press in catches -1- and -3- and pull off connecting hose -4- from air filter -2-. –  Remove throttle valve control unit -J338- → Chapter.

–  Remove support for intake manifold, to do so release nut -2- with screw -1-. Coolant temperature sender -G62- with clamp:

–  Disconnect plug -1- at the coolant temperature sender -G62-. –  Pull off retaining clip, to do so press locks -arrows-. –  Pull out coolant temperature sender -G62--2-.   Note In order to avoid a loss of large amount of coolant, immediately insert new coolant temperature sender -G62- with O-ring into the connection fitting. Coolant temperature sender -G62- with retaining plate:

–  Disconnect plug -2- at the coolant temperature sender -G62-. –  Screw out screws -arrows- and remove the retaining plate -1-. –  Pull out the coolant temperature sender -G62-.   Note In order to avoid a loss of large amount of coolant, immediately insert new coolant temperature sender -G62- with O-ring into the connection fitting. Install Installation is performed in the reverse order, pay attention to the following points:   Note Replace O-ring. t  Tightening torques for support of intake manifold and throttle valve control unit -J338-: → Chapter –  Check the coolant level after carrying out the work procedure → Octavia II.