skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the oil pump (Superb II, Octavia II, Fabia II, Roomster) > < Oil filter holder - Summary of components (Superb II, Octavia II)

Octavia Mk2

Removing and installing the oil pan (Octavia II)
Removing and installing the oil pan (Octavia II)
Special tools and workshop equipment required
t  Socket insert -T10058- or -Steckeinsatz SW 5 -, e.g. -3249-
t  Sealant remover gasket stripper (bearing code GST, bearing article no. R 34402), manufacturer Retech s.r.o.
t  Cleaning and degreasing agent, e.g. -D 000 401 04-
t  Protective goggles and gloves
t  Silicone sealant -D 176 404 A2-
Removing
–  Remove the middle and right sound dampening system → Body Work; Rep. Gr.50.
–  Remove right air guide pipe, to do so pull the retaining clips.
–  Disconnect plug at oil level and oil temperature sender -G266-.
–  Drain engine oil → Octavia ll.
   
–  Unscrew the bolts of oil pan/gearbox -arrows-.
–  Loosen bolts -1 ... 20- crosswise and release.
–  Remove oil pan, if necessary release by applying slight blows with a rubber-headed hammer.
  Note
  S17-0160
Both rear oil pan bolts -1- and -2- are accessible through the recess -arrow- at the flywheel -3-, turn the flywheel appropriately to allow this.
Install
Installation is performed in a similar way in the reverse order. Pay attention to the following points:
  WARNING
Wear protective gloves and goggles when working with gasket remover and degreasing agent!
–  Clear sealing surface on the oil pan from gasket residues with chemical sealant remover.
–  Degrease the sealing surfaces.
–  Cut off nozzle tube at the front marking (Ø of nozzle approx. 3 mm).
  S17-0158
–  Apply silicone sealant bead -arrow- to the clean sealing surface of the oil pan, as shown.
l  Thickness of sealant bead: 2 ... 3 mm.
  Note
t  The sealant bead must not be thicker than 3 mm otherwise excess sealant may get into the oil pan and clogg the strainer in the oil suction pipe.
t  Take particular care when applying the sealant bead in the area of the sealing flange at the rear -arrows-.
t  The oil pan must be installed within 5 minutes after applying the silicone sealant.
  S17-0124
–  Fit on oil pan immediately and tighten the bolts as follows:
–  First of all pre-tighten screws -1 ... 20- crosswise to 5 Nm.
–  Tighten the bolts of the oil pan/gearbox -arrows- to a torque of 45 Nm.
–  Torque screws -1 ... 20- crosswise to 15 Nm.
  Note
t  When installing the oil pan with the engine removed, ensure that the oil pan is flush with the cylinder block at the flywheel side.
t  After installing the oil pan, allow the sealant to dry for about 30 minutes. Only then may engine oil be filled in.
–  Fill with engine oil and check the oil level → Octavia ll.
  S17-0160

Removing and installing the oil pump (Superb II, Octavia II, Fabia II, Roomster) > < Oil filter holder - Summary of components (Superb II, Octavia II)