Octavia Mk2
Summary of components |
1 - | 15 Nm |
2 - | Dipstick |
q | oil level must not exceed max. marking! |
3 - | Filler funnel |
q | to remove from bottom to top carefully press off from guide tube |
4 - | Guide tube |
5 - | Intermediate plate |
q | Engine identification characters BLR, BLX, BLY: |
replace |
q | removing and installing → Chapter |
6 - | Balancing shaft module with oil pump |
q | with pressure relief valve 0.12 MPa (12 bar) |
q | Summary of components → Chapter |
q | removing and installing → Chapter |
q | Engine identification characters BLR, BLX, BLY: |
If the balancing shaft module with oil pump was removed, always replace the intermediate plate. |
7 - | 15 Nm + torque a further 90° (1/4 turn) |
q | replace |
q | pay attention to the different screw lengths → Chapter |
8 - | 15 Nm |
9 - | 8 Nm |
q | only fitted for engine identification character BWA (attachment charge air pipe) |
10 - | Oil pan |
q | clean sealing surface before installing |
q | removing and installing → Chapter |
q | if the oil pan was removed, always replace the intermediate plate (Pos. 5) |
11 - | 15 Nm |
12 - | Oil drain plug, 30 Nm |
q | with captive seal |
q | replace |
13 - | Sprocket |
q | for oil pump |
14 - | 10 Nm |
q | not for engine identification characters BLY, BVZ |
15 - | Protective cap |
q | not for engine identification characters BLY, BVZ |
16 - | Oil level and oil temperature sender -G266 - |
q | not for engine identification characters BLY, BVZ |
17 - | Sealing ring |
q | replace |
q | oil before assembly |
q | not for engine identification characters BLY, BVZ |
18 - | 20 Nm + torque a further 90° (1/4 turn) |
19 - | Chain cover |
20 - | Chain |
21 - | Sealing flange on the belt pulley side |
q | must be positioned on dowel sleeves |
q | removing and installing → Chapter |
q | remove oil pan for removing and installing → Chapter |
q | replace the gasket ring for the crankshaft - on the belt pulley side → Chapter |