skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Securing the engine to the assembly stand > < Removing engine

Octavia Mk2

Removing and installing engine trim panel
Removing and installing engine trim panel
Removing
   
Vehicles with engine identification characters BKD, AZV
–  Pull oil dipstick -1- out of oil dipstick guide.
–  Lift the engine cover at the sides -arrows 2- and pull out towards the front -arrow 3-.
–  Push the oil dipstick back into the oil dipstick guide, so that nothing can fall into the opening.
  S10-0210
Vehicles with engine identification characters BMM
–  Pull the outer -1- and inner -2- engine cover evenly towards the top.
Install
  Note
On vehicles with engine identification characters BKD, AZV, pull the oil dipstick out of the oil dipstick guide before installing and push it back again into the oil dipstick guide after installing.
  Caution
Before installing the engine cover, check the correct position of the fixing elements (ball sockets). If necessary they must be put back into their correct position. Otherwise this can lead to damage to the engine cover.
  S10-0412
–  If necessary, press the ball sockets of the engine cover into the correct position.
–  Place the engine cover onto the fixing points and press it into the catch.
  N10-10274

Securing the engine to the assembly stand > < Removing engine