skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Plug connections at the control for heating and air conditioning system > < Removing and installing heating and air conditioning system control with control unit for air conditioner/ClimaticJ301 up to MY

Octavia Mk2

Removing and installing heating and air conditioning system control with control unit for air conditioner/ClimaticJ301 as of MY 09 (CW 45.08)
Removing and installing heating and air conditioning system control with control unit for air conditioner/Climatic -J301- as of MY 09 (CW 45.08)
Removing
–  Switch off the ignition and all electrical components.
–  Vehicles with mobile phone holder - slacken mobile phone holder → Electrical System → Rep. gr.91.
   
–  Carefully lever out the covering -1- using the disassembly wedge -3409-.
–  Screw out screws -3- (1.5 Nm) and remove the heater control -2- from the dash panel.
–  Disconnect plug.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
t  Check the function of the control unit for air conditioner/Climatic -J301- after the installation.
t  When replacing, carry out the function „Initiate basic setting“ with the → Vehicle diagnostic tester.
t  If the push-button AC does no longer function after replacing the control unit for air conditioner/Climatic -J301-, carry out the function of the „AC compressor inlet“ with the → Vehicle diagnostic tester in the targeted fault finding.
  S87-0338

Plug connections at the control for heating and air conditioning system > < Removing and installing heating and air conditioning system control with control unit for air conditioner/ClimaticJ301 up to MY