skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing heating and air conditioning system control with control unit for air conditioner/ClimaticJ301 as of MY > < Climatic - Air conditioner with manual control - Part 2

Octavia Mk2

Removing and installing heating and air conditioning system control with control unit for air conditioner/ClimaticJ301 up to MY 08 (CW 44.08)
Removing and installing heating and air conditioning system control with control unit for air conditioner/Climatic -J301- up to MY 08 (CW 44.08)
Removing
  Note
t  The heater control consists of two separate housings. Before removing the heater control, bring the rotary knobs into the following position:
t  Heat regulator to „cold“
t  Blower to „0“
t  Direction of vent to „footwell“
–  Switch off the ignition and all electrical components.
–  Vehicles with mobile phone holder - slacken mobile phone holder → Electrical System → Rep. gr.91.
   
–  Carefully lever out the covering -1- using the disassembly wedge -3409-.
–  Screw out screws -3- (1.5 Nm) and remove the heater control -2- from the dash panel.
–  Disconnect plug.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
t  The rotary knobs must be in the same position as for the removal.
t  Check the function of the control unit for air conditioner/Climatic -J301- after the installation.
t  When replacing, carry out the function „Initiate basic setting“ with the → Vehicle diagnostic tester.
  S87-0234

Removing and installing heating and air conditioning system control with control unit for air conditioner/ClimaticJ301 as of MY > < Climatic - Air conditioner with manual control - Part 2