skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Install gasket ring for flange shaft > < Replacing gasket rings for flange shafts at rear final drive (rear final drive installed)

Octavia Mk2

Removing the flange shaft gasket ring
Removing the flange shaft gasket ring
The removal of the gasket ring is identical on both left and right.
–  Removing drive shaft → Running Gear; Rep. gr.42.
–  Place a catch pan under the rear final drive.
Remove the left flange shaft
   
–  Screw the plate -1- of the extractor -T10037- with two screws M8 (30 mm long) onto the flange shaft.
l  The shoulders -arrows- for larger flange diameters point to the outside.
–  Position the nut of the knurled screw -2- from the extractor -T10037- onto the hexagon screw -3-.
–  Pull out the flange shaft with extractor -T10037-.
Removing the right flange shaft
–  Screw the plate of the extractor -T10037- with two screws M8 (30 mm long) onto the flange shaft.
l  The shoulders for larger flange diameters point to the outside.
  S39-0409
–  Fit the nut of the knurled screw -arrow- of the extractor -T10037- in such a way that the start of the thread is aligned with the housing.
–  Pull out the flange shaft with extractor -T10037-.
Proceed as follows for both sides
  S39-0333
–  Pull out gasket ring for flange shaft with ejection lever -MP3-418-.
  S39-0335

Install gasket ring for flange shaft > < Replacing gasket rings for flange shafts at rear final drive (rear final drive installed)