skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Setting overview > < Removing

Octavia Mk2

Install
Install
   
–  Swivel angle gearbox in such a way that the cover -1- points upwards.
–  Place inner ring/tapered-roller bearing in the angle gearbox.
–  Lightly oil new gasket ring at outer surface.
–  Drive in the new gasket ring with thrust piece -T10049- up to the stop, do not twist the new gasket ring.
–  Fill half the space between the sealing lip and dust lip with sealing grease -G 052 128 A1-.
  S39-0381
–  Insert output flange with two-arm extractor-A-, pipe -MP3-414- and thrust plate -MP3-467-, while doing so position the extraction hooks of the extractor on the bottom side of the housing.
   A - Two-arm extractor, e.g. -Kukko 20/10 -
  S39-0382
–  Insert new hexagon nut with locking agent -D 000 600- and tighten to the prescribed tightening torque.
   A - socket wrench insert SW 36
–  Install angle gearbox → Chapter.
–  After installing, check the oil level in the angle gearbox and top up with oil → Chapter.
  S39-0379
Tightening torques
ComponentNm
Oil drain plug60
Nut for output flange1480

1) Always replace nut → Electronic Catalogue of Original Parts
   

Setting overview > < Removing