skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Bleeding the clutch system > < Removing

Octavia Mk2

Install
Install
Installation is performed in the reverse order, pay attention to the following points:
–  grease tappet end with grease -G 000 100-.
   
–  Install slave cylinder and tighten screws -arrows B- to the given tightening torque.
  S30-0141
–  Push the tube-hose line -1- with new gasket ring -2- into the slave cylinder -4- up to the stop.
–  Press in locking clip -3- for attaching the tube-hose line up to the stop.
–  For testing pull on the tube-hose line.
  S30-0186
–  Install bracket -B- at the gearbox and insert the tube-hose line -A-.
–  Remove hose clamp -MP7-602 (3094)-.
  S30-0190
–  If necessary, attach gearbox support to gearbox -arrows A- and tighten.
–  After installing the slave cylinder bleed the clutch system → Chapter.
–  Setting the shift mechanism.
Octavia II → Chapter
Superb II → Chapter
–  Install the battery tray and battery → Electrical System; Rep. gr.27.
–  Install air filter → Engine; Rep. gr.24.
  Note
If the battery earth strap is disconnected and connected, carry out additional operations → Electrical System; Rep. gr.27.
–  Connect earth strap of battery → Electrical System; Rep. gr.27.
  S30-0141
Tightening torques
ComponentNm
Slave cylinder to gearbox → Chapter → Item
bracket for tube-hose line → Chapter → Item
Support to gearbox console and gearbox Octavia II → Chapter
Support to gearbox console and gearbox Superb II → Chapter
Gearbox shift lever to gearshift shaft Octavia II → Chapter
Gearbox shift lever to gearshift shaft Superb II → Chapter
Bowden cable to gearbox Octavia II → Chapter
Bowden cable to gearbox Superb II → Chapter

   

Bleeding the clutch system > < Removing