skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the slave cylinder|Install > < Removing and installing the slave cylinder

Octavia Mk2

Removing
Removing
  Note
If the battery earth strap is disconnected and connected, carry out additional operations → Electrical System; Rep. gr.27.
–  Disconnect the battery-earth strap with the ignition off → Electrical System; Rep. gr.27.
–  Remove air filter → Engine; Rep. gr.24.
–  Remove battery and battery tray → Electrical System; Rep. gr.27.
   
–  Remove lock washer -arrow 1- for shift cable from gearbox shift lever -A-.
Vehicles up to 05.07 (metal relay lever)
–  Remove circlip -arrow 2- for selector cable from relay lever -B-.
–  Remove selector cable and shift cable from the studs.
–  Detach circlip -arrow 3- from the relay lever -B- and remove relay lever.
Vehicles from 06.07 (plastic relay lever)
–  Pull off the shift cable from the stud.
–  Remove relay lever together with cable lock → Chapter.
Continued for all vehicles
–  Remove the gearshift lever -A-, for this step unscrew nut -arrow 4-.
  S30-0189
–  Disconnect the Bowden cable support from gearbox -arrows-.
–  Tie up shift cable and selector cable.
–  Remove bracket -B- from the gearbox and pull off from the tube-hose line -A-.
  S30-0190
–  Remove gearbox support -arrows A- (if applicable).
–  Place a non-fluffing cloth under the slave cylinder.
  Note
Make sure no brake fluid comes into contact with the gearbox. If this is the case, this point must be cleaned thoroughly.
–  Pull retaining clip for tube-hose line out of the slave cylinder up to the stop.
–  Pull tube-hose line out of the slave cylinder.
  S30-0141
–  Pinch off the tube-hose line to the master cylinder with the hose clamp -MP7-602 (3094)- (if the tube-hose line to the master cylinder is made out of plastic, do not use the hose clamp -MP7–602-).
  S30-0184
–  Removing the slave cylinder -arrows B-.
–  Pull out locking clip -1- up to the stop and thus pull the tube-hose line -2- out of the slave cylinder (close plastic tube-hose line in a suitable manner).
  Note
Do not depress the clutch pedal.
  S30-0141

Removing and installing the slave cylinder|Install > < Removing and installing the slave cylinder