skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing gasket rings for right and left flange shaft (rear final drive installed)|Install > < Replacing gasket rings for right and left flange shaft (rear final drive installed)

Octavia Mk2

Removing
Removing
The removal of the gasket ring is identical on both left and right.
–  Removing flange shaft → Chassis; Rep. gr.42.
–  Place a catch pan under the rear final drive.
Remove the left flange shaft
   
–  Manually screw the plate -1- of the extractor -T10037- with two screws M8 (30 mm long) onto the flange shaft.
l  The shoulders -arrows- for larger flange diameters point to the outside.
–  Position the nut of the knurled screw -2- of the extractor -T10037- onto the hexagon screw -3-.
–  Pull out the flange shaft with extractor -T10037-.
Removing the right flange shaft
–  Manually screw the plate of the extractor -T10037- with two screws M8 (30 mm long) onto the flange shaft.
l  The shoulders for larger flange diameters point to the outside.
  S39-0409
–  Position the nut of the knurled screw -arrow- of theextractor -T10037- flush with the beginning of the thread at the housing.
–  Pull out the flange shaft with extractor -T10037-.
Proceed as follows for both sides
  S39-0333
–  Lever off gasket ring for flange shaft with ejection lever -MP3-418 (VW 681)-.
  S39-0335

Replacing gasket rings for right and left flange shaft (rear final drive installed)|Install > < Replacing gasket rings for right and left flange shaft (rear final drive installed)