Inspecting the gearshift mechanism |
WARNING Before working on the engine when the engine is running, insert the selector lever in position „P“ and apply handbrake. |
|
t
| In selector lever positions „S“, „D“, „R“ and Tiptronic position it must not be possible to activate the starter. |
t
| At speeds above 5 km/h and shifting in selector lever position „N“ the selector lever lock solenoid must not engage and block the selector lever. The selector lever can be shifted in a driving position. |
t
| At speeds below 5 km/h (virtual standstill) and shifting in selector lever position „N“ the selector lever lock solenoid must only engage after approx. 1 s. The selector lever can only be moved from position „N“ by activating the brake pedal. |
Selector lever in position „P“ and ignition switched on: |
l
| Brake pedal is not operated: |
The selector lever is locked and cannot be moved out of position „P“. The selector lever lock solenoid blocks the selector lever. |
l
| Brake pedal is operated: |
The selector lever lock solenoid releases the selector lever. It is possible to engage a driving gear position. Slowly shift selector lever from „P“ through „R, N, D, S“; while doing so check whether the selector lever position in the dash panel insert corresponds with the actual selector lever position. |
Selector lever in position „N“ and ignition switched on: |
l
| Brake pedal is not operated: |
The selector lever is locked and cannot be moved out of position „N“. The selector lever lock solenoid blocks the selector lever. |
l
| Brake pedal is operated: |
The selector lever lock solenoid releases the selector lever. It is possible to engage a driving gear position. |
Selector lever in position „D“ ignition and light switched on: |
l
| Selector lever in Tiptronic gear leads to: |
The lighting up of the „D“ symbol in the selector lever position indicator should go out and the „+“ and „-“ symbols should light up. |
When the gear selector lever is put into the Tiptronic gate, the selector lever position display in the dash panel insert should change from „PRNDS“ to „654321“. |
–
| Move selector lever in the Tiptronic gear to „+“ and „-“. |
When the gear selector lever is put into a higher or a lower driving position, the selector lever position display in the dash panel insert should change. |
–
| Inspecting and adjusting the selector lever control cable → Chapter. |
–
| Checking the ignition key removal lock: |
|
|
|