Skoda Workshop Service and Repair Manuals

Removing –  Shift selector lever to position „N“. –  Switch off ignition.   Note Make sure that the vehicle does not put itself into motion. –  Open ashtray in the centre console. For vehicles Octavia II

–  Release the front right cover -arrow- using the release tool -T30098-. Then release the rear right and centre cover -arrow-. For vehicles Superb II

–  Remove cover using the release tool -T30098-. Pull up rear left and right cover -arrows-. Continued for all vehicles –  Before removing the handle pull out lock button over its pressure point and secure it with a cable strap or a suitable wire. This can prevent that the button is inadvertently pressed into the handle.

For vehicles Octavia II

For vehicles Superb II Continued for all vehicles

–  Release plug connection -C- from the lamp for selector lever scale illumination -L101- and disconnect.   Note t  Ignore pos. -A-, -B- and -1-. t  As of production date 11.09 the shift mechanism is changed, the 4-pin plug connection -B- and the selector lever lock solenoid -N110--1- are already located in the shift mechanism → Chapter.

–  Open the warm-type clamp below the handle -arrow- and pull off handle with cover.