Skoda Workshop Service and Repair Manuals > Octavia Mk2 > Power transmission | Gearbox 09G | Automatic gearbox, gears, control | Removing and installing oil pan, oil filter, slide valve body and internal wiring looms | Removing and installing the gearbox input r.p.m. senderG182

Removing and installing the gearbox input r.p.m. senderG182

Removing and installing the gearbox input r.p.m. sender -G182-

Note

General repair information → Chapter.

WARNING

Observe measures when disconnecting and connecting the battery → Electrical System; Rep. gr.27.

Removing gearbox input r.p.m. sender -G182-

–	Disconnect the battery-earth strap with the ignition off → Electrical System; Rep. gr.27.

–	Removing the oil pan → Chapter.

–	Removing oil filter → Chapter.

–	Remove the slide valve body → Chapter.

–	Release screw -1-.

–	Pull gearbox input r.p.m. sender -G182- with cable -A- out of the gearbox.

Installing gearbox input r.p.m. sender -G182-

Installation is performed in the reverse order, pay attention to the following points:

–	Carefully press gearbox input r.p.m. sender -G182- up to the stop into the gearbox.

Tightening torque

Component	Nm
Gearbox input r.p.m. sender -G182- to gearbox, M6 screw	→ Chapter

Skoda Workshop Service and Repair Manuals