skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing wiring loom with 8-pin plug and integrated gearbox oil temperature senderG93 > < Removing and installing the slide valve body

Octavia Mk2

removing and installing wiring loom with 14-pin plug
   
removing and installing wiring loom with 14-pin plug
A - 14-pin plug
B - Wiring loom for 14-pin plug
q   Designation of solenoid valves and wiring loom routing → Chapter

  Note
General repair information → Chapter.
  WARNING
Observe measures when disconnecting and connecting the battery → Electrical System; Rep. gr.27.
Removing wiring loom with 14-pin plug
–  Disconnect the battery-earth strap with the ignition off → Electrical System; Rep. gr.27.
–  Removing the oil pan → Chapter.
–  Removing oil filter → Chapter.
–  Remove the slide valve body → Chapter.
   
With gearbox installed
–  Unplug the 14 pin plug connection -A- from gearbox plug.
  S38-0032
Continued for all gearboxes
–  Unscrew fixing screw of 14-pin plug outside the gearbox housing.
–  Pull the plug out of the gearbox housing and carefully guide through the wiring loom -D-.
Install wiring loom with 14-pin plug
Installation is performed in the reverse order, pay attention to the following points:
–  Replace O-ring at plug → Electronic Catalogue of Original Parts.
–  Moisten O-ring with ATF.
–  Press plug with positioned O-ring up to the stop into the gearbox.
  S37-0211
Tightening torque
ComponentNm
Locking screw for 14-pin plug → Chapter

   

Removing and installing wiring loom with 8-pin plug and integrated gearbox oil temperature senderG93 > < Removing and installing the slide valve body