skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Replacing gasket ring for right flange shaft (Octavia II, Superb II, Yeti)|Install > < Replacing gasket ring for right flange shaft (Octavia II, Superb II, Yeti)

Octavia Mk2

Removing
Removing
  Note
t  Observe the general repair instructions → Chapter.
t  Do not remove both drive shafts simultaneously from the gearbox. Then it is no longer possible to hold the opposite wheel in order to remove or install the screws of the rigid shafts or flange shafts.
t  Do not loosen both fixing screws in the left and right rigid shafts or flange shafts at the same time. If the differential bevel gears twist, it will be difficult to reinstall the screws.
–  Shift selector lever into position „P“.
–  Remove the sound dampening system → Body Work; Rep. gr.50.
   
–  Remove the protective cap for right drive shaft from the engine -arrows-.
–  Remove right drive shaft from flange shaft → Chassis; Rep. gr.40.
  Note
The drive shaft must not hang down, because overstretching will cause damage to the inner joint.
  N34-11369
–  Tie up the drive shaft as far as possible. Avoid damaging the paintwork on the drive shaft during this operation.
–  Position the catch pan under the gearbox.
  N37-10433
–  Unscrew screw for flange shaft with socket insert -T10107A- or commercially available socket insert 6 mm.
–  Take out the flange shaft.
–  Remove the gasket ring of the flange shaft e.g with extractor tool -T20143- or tyre iron.
  N34-11389

Replacing gasket ring for right flange shaft (Octavia II, Superb II, Yeti)|Install > < Replacing gasket ring for right flange shaft (Octavia II, Superb II, Yeti)