skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Repairing clutch > < Removing and installing slave cylinder (Octavia II)|Install

Octavia Mk2

Bleed the clutch control
Bleed the clutch control
Special tools and workshop equipment required
t  Brake filling and bleeding device - VAS 5234- or ROMESS
  Note
t  When performing the following work, make sure that no brake fluid comes into contact with the frame side rail or the gearbox.
t  A pre-filling of the system is not necessary!
Brake fluid specification → Chassis; Rep. gr.00.
–  Remove air filter → Engine; Rep. gr.24.
–  Connect the brake filling and bleeding device.
   
To bleed, use the bleeder hose-arrow-.
–  Connect bleeder hose -arrow- with the drip bottle of the brake bleeding device.
–  Fit the bleeder hose -arrow- onto the vent valve.
–  Activate system with a pressure of 0.2 MPa (2 bar).
–  Open vent valve.
–  Allow approx. 100 cm3 of brake fluid to flow out until no more air bubbles are visible.
–  Close vent valve.
–  Activate pedal forcefully from stop to stop between 10 and 15 times.
–  Activate system with a pressure of 0.2 MPa (2 bar).
–  Open vent valve.
–  Allow approx. 50 cm3 more brake fluid to flow out.
–  Close vent valve.
–  After completing the bleeding procedure activate the clutch pedal repeatedly.
–  Install air filter → Engine; Rep. gr.24.
  S30-0089

Repairing clutch > < Removing and installing slave cylinder (Octavia II)|Install