l
| The shift lever guide must protrude out of the shift housing as far as the stop. |
–
| Lift the upper leg -A- of the pressure spring over the stud of the selector angle plate. |
l
| Use a new bearing shell -B-. |
–
| Grease the bearing shell and the bearing ball of the shift lever guide with grease -G 000 450 02-. |
–
| Press the bearing shell up to stop onto the bearing ball of the shift lever guide. |
–
| Remove shift housing from the insert base -T10083-. |
–
| Press the bearing shell into the shift housing -arrows-. |
l
| All catch pegs must click audibly. |
–
| Insert the lower leg -C- of the pressure spring into the guide. |
–
| Lift the upper leg -A- of the pressure spring over the stud of the selector angle plate into the guide. |
–
| Mount shift lever, shift cable, selector cable and floor plate → Chapter. |
–
| Install gearshift mechanism (Octavia II) → Chapter. |
–
| Install gearshift mechanism (Superb II) → Chapter. |
–
| Install gearshift mechanism (Yeti) → Chapter |
|
|
|