skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Assembling together > < Disassembling and assembling the gearshift mechanism

Octavia Mk2

Dismantling
Dismantling
–  Remove gearshift mechanism (Octavia II) → Chapter.
–  Remove gearshift mechanism (Superb II) → Chapter.
–  Remove gearshift mechanism (Yeti) → Chapter
   
–  Bend up the tabs -arrows- of the floor plate for shift mechanism with a screwdriver and remove the floor plate; (the tabs in the front area of the floor plate are not shown in the illustration).
–  Remove gasket from shift housing.
–  Remove shift cable and selector cable from the shift housing → Chapter.
  A34-0588
–  Lift the upper leg -A- of the pressure spring over the tabs of the selector angle.
–  Use a screwdriver to press the catches -arrows- of the bearing shell in direction of the bearing ball for the shift lever guide; if necessary break off the catches -arrows-.
  N34-10921
–  Lever bearing shell -A- with shift lever guide and shift lever -B- out of the shift housing.
–  Then press the bearing shell off the bearing ball for the shift lever guide and remove.
  N34-10922
l  During further work procedure observe the guides -A-.
l  The guides -A- must not break off.
–  Lever the lower leg of the pressure spring up to the stop onto the shoulder at the selector angle plate -direction of arrow 1-.
–  Now pull up the shift lever guide as far as the stop and pull the ball stud out of the selector angle plate -direction of arrow 2-.
  N34-10865
–  Then turn the shift lever guide in -direction of arrow 1-.
l  The stud -arrow 2- must be located in the recess of the shift housing.
–  Afterwards, swivel out the shift lever guide with shift lever in -direction of arrow 3-.
  N34-10924

Assembling together > < Disassembling and assembling the gearshift mechanism